Automatic Check Of Refrigerant Level - Samsung AM040KXMDEH/EU Service Manual

8-2. Automatic Check of Refrigerant Level

This function determines the refrigerant level of system through the refrigerant level checking operation.
Press the tact switch "K2" 4 times.
Beyond the temperature range of warranty, it is not possible to obtain an accurate result.
- Indoor: 20 ~ 32°C
Note
- Outdoor: 5 ~ 43°C
When the operational cycle is not stable, the refrigerant level detection operation may be forcefully terminated.
When the system has not been used for a long time prior to the refrigerant level detection operation, the accuracy may be dropped.
Hence, please try to run the system in cooling mode for 30 or minutes in advance.
According to the installation environment, the refrigerant level checking result may not be accurate when running the system in
protection mode.
Action to Judgment Result
Excessive Refrigerant Level: After removing 5% of refrigerant from the calculated refrigerant level, please try to run the refrigerant level
detection function again.
Insufficient Refrigerant Level: After adding 5% of refrigerant to the calculated refrigerant level, please try to run the refrigerant level
detection function again.
Excessive Lack of Refrigerant: After adding 10% of refrigerant to the calculated refrigerant level, please try to run the refrigerant level
detection function again.
Unable to Judge: Please check whether the system operates within the temperature range of warranty for the refrigerant level detection
operation. Please check if there is any other problem in the system through test operation.
Meeting the temperature conditions
Check the refrigerant level
Determine the refrigerant level
(Normal) (Excessive)
Auto Commissioning & Management System & Amount of Refrigerant Check Function
Start
Enter the S-NET pro signal.
(Insufficient) (Unable to judge)
Finish