Table of Contents
Advertisement
INSTALLATION: SCALE SECTION-Continued
5)
Attach the scale section to the existing carriage. The top cleats of the scale
will hold it to the carriage.
6)
Make sure the top cleats are seated solid on the top of the carriage. The
center stop pin should also be seated solid in the center notch of the carriage.
7)
Raise the carriage and adjust the carriage adjustment bolts so that both
bolts touch the plate of the carriage and daylight can be seen between
the scale section and the carriage face. (lock down the bolts with locking
nuts, 1 1/2-inch). Make sure the bolts are tight.
8)
Install the bottom cleats provided with your system. Make sure they are
tight. There must be daylight showing on the back and bottom of the
cleats. No part of the cleat should touch the bottom of the carriage. If
this happens, repeatability will be affected. Corrective action would be
to install washers between the cleat and scale back plate to provide a
clearance gap.
9)
Remove the fork stops and attach the forks to the front of the scale.
10) Reinstall the fork stops.
11) Remove the lifting eye and reinstall the cable protection guard and bolt.
The scale section installation is now complete.
7
Advertisement
Table of Contents
