Table of Contents
Advertisement
T1 Version
T2 Display
T3 Buttons
T4 A to D
T5 Serial
T6 Setup data
T7 Default
END
4.0 TESTING PROCEDURES
4.1 Testing Menu Definitions:
Displays Software Version.
Lights all display segments and indicating LEDs
Press the
ZERO
Press the
GRS/NET
Press the
Tare
Press the
lb/kg
Pressing the
PRINT
Displays raw counts where a 1mV/V signal from the scale
will display 25,000 counts.
When in angle mode down
and Raw counts.
Serial communications can be verified by connecting pins
2 and 3 on the serial port. A single character will be echoed
and pass or fail will be displayed.
Setup data will be sent out on the printer port.
Resets the meter back to factory defaults clearing all
calibration and setup data. "r you sure?" will be displayed
then press the
the
Print
key to reset the meter to factory default.
Exits back to the main Menu.
key, b1 will be displayed.
key, b2 will be displayed.
key, b3 will be displayed.
key, b4 will be displayed.
key will exit back to the menu T3.
GRS/NET
Tare
key to exit without defaulting, or press
will cycle Pitch, Roll
21
Advertisement
Table of Contents
