montpellier ICHT02101 Installation And Operating Manual

montpellier ICHT02101 Installation And Operating Manual

90cm t-shaped island hood

Advertisement

Quick Links

90cm T-Shaped Island Hood
ICHT02101 - Stainless Steel
Cod:0103086060

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ICHT02101 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for montpellier ICHT02101

  • Page 1 90cm T-Shaped Island Hood ICHT02101 - Stainless Steel Cod:0103086060...
  • Page 2 Welcome Thank you for choosing this Montpellier T-Shaped Cooker Hood. Our Hoods have been designed to provide you with the best combination of style, reliability and performance to give you years of trouble-free use. You may be familiar with a similar product, but please take time to read these instructions carefully before installing or using your Cooker Hood to ensure you get the most from your purchase.
  • Page 3 Important The manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product Please note that the manufacturer reserves the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment. This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or who lack experience or knowledge about it, unless they have had super-,ision or instructions on how to use the appliance by someone who is responsible for their safety.
  • Page 4: Using Your Extractor

    Using Your Extractor For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking. Fig. 1 ON/OFF Key/Delay Timer: again. The display will show the symbol flashing for 4 seconds. By pressing the keys , the delay timer can be adjusted (max.
  • Page 5: Care And Maintenance

    Care and Maintenance IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. solution of water and mild detergent and drying to a shine with a clean cloth.
  • Page 6 Charcoal filter installation (Re-circulating only) In re-circulating discharge, air is vented back into the kitchen through the openning in the range hood. If you do not anticipate heavy cooking, this method may be preferable. Re-circulating dscharge requires the use of charcoal filters (included) to remove odors. Attention - The range hood leaving factory is with charcoal filters installed.
  • Page 7 NOTE: LED lights replacement must be done by a qualified electrician. IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Check with your local retailer or dealer to buy new same LED lights for replacement.
  • Page 8: Mains Electricity Connection

    Mains Electricity Connection THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY DOUBLE POLE SWITCHED A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE FUSE SPUR OUTLET SWITCHED FUSE SPUR OUTLET AND PROTECTED BY A 3A FUSE. Warning! This appliance MUST be earthed. We recommend that the appliance is connected by a qualified electrician who is a member of the N.I.C.E.I.C.
  • Page 9: Installation

    INSTALLATION To accommodate different user requirements, the product can be installed in 2 ways (see Fig 5 and Fig 6). Fig. 5 Fig. 6...
  • Page 10 INSTALLATION Tools required Fix damper on the unit by 4 pieces ST4X10 screws. Fig. 7 Fig. 8 Screw 4 pieces plastic expanding plugs on ceiling as Fix lower sliding rail on the unit by 16 pieces ST4X10 installation drawing. screws. Fig.
  • Page 11 Put the outer chimney on the unit. Put the inner chimney on the unit. Fig. 14 Fig. 13 Fix the unit on the ceiling by 4 pieces ST4X35 screws and fix inner chimney on the bracket by 2 pieces ST4X10 screws. Fig.
  • Page 12 Model identification ICHT02101 Annual Energy Consumption Hood 22.3 Hood 63.1 Hood Measured airflow at Best 206.3 Measured Pressure at Best Maximum airflow 360.7 Measured electric power at Best 89.3 g i l n i t Average illumination of the Middle...
  • Page 13: After-Sales Assistance

    Your 2 year Manufacturer’s guarantee THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS. Your new Montpellier appliance carries a free guarantee which protects you against the cost of repairs during the first 24 months from date of purchase provided that: Any claim is accompanied by evidence of the model reference, model serial number and proof of purchase, such as a Sales Receipt, showing that the appliance was purchased within the 24 months prior to the date of claim.
  • Page 14 Montpellier Domestic Appliances Ltd. Unit 1, Tewkesbury Retail Park, Northway Lane, www.montpellier-appliances.com The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

Table of Contents