montpellier MIN60S Installation And Operation Instructions Manual
montpellier MIN60S Installation And Operation Instructions Manual

montpellier MIN60S Installation And Operation Instructions Manual

Integrated cooker hood

Advertisement

Quick Links

MIN60S
Cod:0103086956-00.02

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MIN60S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for montpellier MIN60S

  • Page 1 MIN60S Cod:0103086956-00.02...
  • Page 4: Using Your Extractor

    Using your extractor For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking. Fig. 1 Control Panel A – Light switch B –...
  • Page 6 1. Remove the cover panel by pushing the fixing clips up and then lifting the panel forwards. 2. Remove the filter retaining wires from the cover panel. 3. Remove the grease filter and wash by hand in a lukewarm solution of water and mild detergent. Once clean squeeze the grease filter but DO NOT wring it out.
  • Page 7: Changing The Light

    To ensure best performance of your extractor, you should replace the charcoal filters every four to six months, depending on use. To attach a new charcoal filter, follow the steps below: 1. Remove the cover panel (acrylic filter model) or grease filter (aluminium filter model) as described above.
  • Page 8 Only use bulbs recommended for your extractor. Do not fit bulbs of a higher power rating. Bulbs of a lower power rating may be ad- equate for use, generally last longer and use less energy. Spare bulbs are available from MONTPELLIER Customer Care or from your local DIY shop.
  • Page 9: Electrical Information

    PROTECTION LINE 5A Fuse is installed inside the plug to protection line. FUSE 5A Electrical information Mains electrical voltage: 230 – 240Vac. Total rated power consumption: Troubleshooting If your extractor is not working: 2. Check that the fuse in the spur has not blown.
  • Page 10: Installation Preparation

    Installation - preparation When the extractor is to be installed above an electric hob, the minimum distance between the hob and extractor must exceed 600mm (650mm is recommended). When the extractor is to be installed above a gas hob, the minimum distance between the hob and extractor must exceed 700mm (750mm is recommended).
  • Page 11: Installation - Mounting

    The metal casing of this appliance has been coated with a preservative to protect it during transport and storage. This should be removed during installation by using a non-abrasive stainless steel cleaner. Always follow the instructions given with the cleaner being used.
  • Page 12 Fig4 Fig. 5 Ducting The ducting used should be rigid circular pipe and must be manufactured from fire retardant material, produced to BS 476 or DIN 4102-B1. Wherever possible utilise rigid circular pipe which has a smooth interior, rather than the expanding concertina type ducting. The 4 metres with 1 x 90°...
  • Page 13 Model Identification MIN60S Annual Energy Consumption 26.6 Hood Time Increase factor Hood 69.1 Hood Measured Airflow at Best 99.2 Measured Pressure at Best Maximum Airflow 193.2 Measured Electric Power at Best 38.2 Nominal Lighting P Average Illumination of the Middle...
  • Page 14 THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS. Your new Montpellier appliance carries a free guarantee which protects you against the cost of repairs during the Any claim is accompanied by evidence of the model reference, model serial number and proof of purchase, such of claim.

Table of Contents