Start And Stop Scanning - RCA Prodigi RDR1520 Series Instruction Manual

20
Prodigi
Nuisance channel delete
When scan remains on one channel, press
the pre-programmed nuisance channel key,
the radio will continue to scan next channel,
and will not scan this channel afterward. But
when the scan function closes and then opens
the scan function again, the radio will resume
scanning this channel.

Start and stop scanning

1. Press pre-programmed scan key or use
the channel knob to select one auto scan
channel.
2. When scan activated, LED indicator flashes
yellow, you can hear a confirm tone. When
scanning stops, LED indicator stops and an
alarm tone is heard.
Dual priority channel scan
When set up one priority channel, activate
the priority scan function, this scan uses Cyclic
scan mode, which always scans the priority
channel during each common scan.
RDR1520 Series Professional Digital Two-Way Radio Instruction Manual
TM
Copyright © 2019 RCA Communications Systems
??? In time of scan, response the
transmission scan
The radio remain in the activated channel/group.
The time of the radio keep in this channel
mean Scan hold time. ???
1. Hold the radio 1-2 inches (2.5-5cm) distance
from your mouth, If "CH free indication"
was enabled, you will hear the short beep
tone when your partner releases PTT, it
means the channel is free and wait for your
response.
2. In the scan hold time, press PTT and the LED
indicates red.
3. When you hear the Call permit tone (if
enabled), speak into the mic.
4. Release PTT to receive.
5. If you don't respond during the hold time,
the radio continues to scan other channels.