Equinox Systems Arcus 2000 User Manual page 8

Mode settings:
Press the button on the unit to display 'Mode', you can now select between 'Low fog mode' and
MENU
'Low haze mode' (water vapour only) by using the
Timer mode:
Press the button on the unit to display 'Timer Interval Duration', you can now adjust the interval
MENU
time from 1s to 600s by using the
Press the button to display 'Timer Output Duration', you can now adjust the output time from
MENU
1s to 600s by using the
Press the button to display 'Timer Volume Output', you can now adjust the output volume from
MENU
1% to 100% by using the
Press the button to display 'Fan speed', you can now adjust the fan volume from
MENU
1% to 100% by using the
Once set you can then use the
The display will show:
Interval: ___S
Duration: ___S
with the settings previously applied.
Press the button once to stop output.
STOP
Manual mode:
MANUAL
Press the button on the unit to display:
START
FOG VOLUME ___%
FAN SPEED ___%
Press the button to switch between 'FOG VOLUME' and 'FAN SPEED', you can now adjust the
MENU
fog volume from 0% to 100% and fan speed from 1% to 100% by using the
Press the button once to stop output.
STOP
Please note: the 'FOG VOLUME' setting will be inaccessible when the unit is in Low Haze Mode.
Stop
output
www.prolight.co.uk
and
and buttons.
and buttons.
and buttons.
button to enable this mode.
TIMER
Remote control:
Output
fog
To control the unit via the wireless remote, connect the receiver to
the remote control input on the rear of the unit. Once this is done
manual mode can be switched on or off with the lock and unlock
buttons as shown on the left. The volume output and fan speed
must be set prior as this cannot be controlled from the remote.
Please note: the 'FOG VOLUME' setting will be unaccessible when
the unit is in Low Haze Mode.
and buttons.
buttons.
Arcus 2000 Low Fogger User Manual
Operating instructions Operating instructions
and buttons.
8