Bradford White RG130T*N Series Service Manual page 27

SERVICE PROCEDURE RG-VI
Gas Control Testing, Disassembly &
Replacement (Honeywell)
GAS CONTROL REPLACEMENT
Step 9. Reinstallation of inner door assembly (continued).
d) Firmly place right side inner door flange against the left side inner door flange and
e) Align right side inner door to combustion chamber and verify the fastener holes of
DO NOT OVER TIGHTEN SCREWS. Verify both left and right sides of the inner door are properly
Step 10. Reconnect (2) red wire leads from pilot assembly and Gas Control to resettable thermal switch.
Note: wire terminations are interchangeable with either resettable thermal switch connection.
Step 11. Replace outer jacket burner access door.
Step 12. Reconnect gas supply to gas control.
Step 13. Resume water supply to water heater. Be sure tank is full of water before resuming operation.
Step 14. To resume operation, follow the instructions located on the lighting instruction label or the lighting
instructions located in the installation and operation manual.
secure with (2) hex drive screws from step 6c. DO NOT OVER TIGHTEN SCREWS.
the combustion chamber are aligned with the right side inner door slotted openings.
Verify seal integrity around combustion opening. Secure right side inner door using
(2) hex drive screws from step 6b.
SERVICE PROCEDURE RG-VI
Gas Control Testing, Disassembly &
Replacement (Honeywell)
GAS CONTROL REPLACEMENT
Step 9. Reinstallation of inner door assembly (continue
DO NOT OVER TIGHTEN SCREWS. Verify bot
Step 10. Reconnect (2) red wire leads from pilot assembl
Note: wire terminations are interchangeable with
Step 11. Replace outer jacket burner access door.
CAUTION
Use back up wrench on wrench boss
Step 12. Reconnect gas supply to gas control.
of gas control, never use back up
wrench on body of gas control.
Step 13. Resume water supply to water heater. Be sure t
Step 14. To resume operation, follow the instructions loca
instructions located in the installation and operat
d) Firmly place right side inner door fl
secure with (2) hex drive screws fr
e) Align right side inner door to combu
the combustion chamber are align
Verify seal integrity around combu
(2) hex drive screws from step 6b.
27
Us
of
wre
27