Siemens SIMATIC IFP Basic Series Operating Instructions Manual page 29

Requirements
● All packaging components and protective films have been removed.
● VESA support application (for example, an arm or a stand) from a third party
Procedure
Note
Make sure your support application is VESA100 compliant. Otherwise, you cannot use it to
support the IFP Basic.
Note
Observe the torques
If you use too much torque to tighten the screws of the screws for fastening the device to a
support arm or stand, the support arm may be damaged. If you tighten the screws with a
torque that is too low, the device is not sealed.
Tighten the screws with the following torques, which may not be exceeded.
Adhere to the torque specifications of the third-party vendors:
Siemens recommends you use 1.5 Nm tightening torque to connect the device and the
VESA mounting interface
VESA adapter does not influent heat dissipation.
IFP Basic
Operating Instructions, 03/2019, A5E46178354 - AB
Installing and connecting the device
3.2 Installing the IFP Basic
29