Setting The Clock To Stamp The Recorded Time - Sony MZ-R30 Analog PCLink Operating Instructions Manual

Setting the clock to
stamp the recorded
time
To stamp the date and time on the MD
when you record, you first need to set the
clock. When you use the recorder for the
first time or after a long period of disuse,
charge the built-in battery for the clock
after setting the clock.
=
CLOCK SET
(on the bottom)
1
Connect the power source.
Use the supplied AC power adaptor.
2
Press CLOCK SET at the bottom of
the recorder.
Use a pointed object.
The digits of the year flash.
AM
3
Enter the current year by pressing
or + .
=
To change the digits rapidly, keep
pressing = or +
+
(
DATE
.
4
Press ( .
The digit of the month flashes.
5
Repeat steps 3 and 4 to enter the
current month, date, hour, and
minute.
When you press (
the clock starts operating.
If you make a mistake while
setting the clock
Press p , and set the clock again from step
2. You can skip a step by pressing ( .
To display the current time
When the recorder is not operating or
while recording, press DISPLAY
repeatedly until the current time appears
in the display.
To display the time in the 24-
hour system
While setting the clock, press DISPLAY.
To display the time in the 12-hour system,
press DISPLAY again.
Charging the built-in battery for the
clock
After setting the clock, leave the recorder
connected to the AC power for about 2 hours
to charge the built-in battery for the clock.
Once charged, the built-in battery should last
about a month without connecting to any of
the power sources. The recorder will
automatically charge the built-in battery while
connected to AC power, dry batteries or a
rechargeable battery.
to set the minute,
15
-EN