While Using Group Function - Sony MZ-N510CK Notes on installing & operating OpenMG Operating Instructions Manual

Symptom
Track marks
cannot be erased.
The disc cannot be
edited on another
component.
"TrFULL" appears
even before the
disc has reached
the maximum
track number or
recording time.

While using group function

Symptom
The group
function does not
operate.
A track cannot be
recorded to a new
group. A new
group cannot be
created.
Cause/Remedy
• This is due to the MiniDisc system limitations. When the data of a
track is fragmented, the track mark of a fragment under 12 seconds
long (recorded in SP stereo), 24 seconds long (recorded in LP2
stereo mode or monaural mode), or 48 seconds long (recorded in
LP4 stereo mode) cannot be erased. You cannot combine tracks
recorded in different recording modes, e.g., a track recorded in
stereo and a track recorded in monaural; nor can you combine a
track recorded with digital connection and a track recorded with
analog connection.
• The component does not support LP2 stereo or LP4 stereo.
, Edit on other component that support LP2 stereo or LP4 stereo.
• This is due to the MiniDisc system limitation. Repeated recording
and erasing may cause fragmentation and scattering of data.
Although those scattered data can be read, each fragment is
counted as a track. In this case, the number of tracks may reach 254
and further recording is not possible. To continue recording, erase
unnecessary tracks.
Cause/Remedy
• While using a disc with no group setting, an attempt was made to
select some group-related menu.
, Use a disc with group setting.
• This is due to the MiniDisc system limitations. Group information
has been written to the area where the disc name is stored. The disc
name and track names are recorded in the same area, which can
store a maximum of approximately 1,700 characters. If the total
number exceeds this amount, a new group cannot be created even
though group mode is on. It is also impossible to make group
settings at this time.
65