Explanations - Sony MZ-N510CK Notes on installing & operating OpenMG Operating Instructions Manual

Explanations

Difference between digital (optical) and analog (line) inputs
The input jack of this recorder works as both digital and analog input jacks. Connect the
recorder to a CD player or a cassette recorder using either digital (optical) input or analog
(line) input. To record, see "Recording an MD right away!" (page 17) to record using
digital (optical) input, and "Recording from a TV or a radio (Analog Recording)" (page 25)
to record using analog (line) input.
Difference
Connectable
source
Usable cord
Signal from
the source
Track
1)
marks
Recorded
sound level
1)
You can erase unnecessary marks after recording. ("Combining tracks (combine)", page 40).
Note
Track marks may be copied incorrectly:
• when you record from some CD players or multi disc players using digital (optical) input.
• when the source is in shuffle or program play mode while recording using digital (optical) input. In
this case, play the source in normal play mode.
• when programs with audio that is digitally broadcast (e.g., digital TV) are recorded through the digital
(optical) input.
70
Digital (optical) input
Equipment with an digital (optical)
output jack (CD player, DVD player,
etc.)
Optical cable (with an optical or an
optical-mini plug) (page 18)
Digital
Marked (copied) automatically
• at the same positions as the source
(when the sound source is a CD or an
MD).
• after more than 2 seconds of no
sound (page 71) or low-level segment
(with a sound source other than a CD
or an MD).
• when the recorder is paused (3
seconds of no sound is encountered
while synchro-recording)
Same as the source.
Can also be adjusted manually (Digital
REC level control) ("Adjusting the
recording level manually", page 27).
Analog (line) input
Equipment with an analog (line)
output jack (Cassette deck, radio,
record player, etc.)
Line cable (with 2 phono plugs
or a stereo-mini plug) (page 25)
Analog
Even when a digital source (such
as a CD) is connected, the signal
sent to the recorder is analog.
Marked automatically
• after more than 2 seconds of no
sound (page 71) or low-level
segment.
• when the recorder is paused
while recording.
Adjusted automatically. Can also
be adjusted manually ("Adjusting
the recording level manually",
page 27).