Labeling Recordings (Title Function) - Sony MXD-D1 Operating Instructions Manual

Labeling Recordings
(Title Function)
You can create titles for your recorded MDs and tracks.
Titles — which may consist of uppercase and
lowercase letters, numbers and symbols for a
maximum of about 1,700 characters per disc — appear
in the display during MD operation.
See "Labeling tracks and MDs with the remote" on
page 36 for use of the remote.
§
· P p
0/)
Use the following procedure to label a track or an MD.
You can label a track while it is playing, pausing or
recording. If the track is playing or recording, be
sure to finish labeling before the track ends. If the
track ends before you have completed the labeling
procedure, the characters already entered are not
recorded and the track will remain unlabeled.
1
Press EDIT/NO repeatedly until "Name in ?"
appears in the display, then do the following:
To label Make sure that the player is
A track Playing, pausing, recording the track to be
labeled, or stopped after locating the track
to be labeled
An MD Stopped with no track number appearing
in the display
2
Press YES.
A flashing cursor appears in the display.
3
Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! " # $ % & ' ( ) * + , – . / : ; < = > ? @ _ `
≠ AMS ±
EDIT/NO
§
≠ AMS ±
• •
0 )
YES
Editing Recorded MDs
4
Press AMS to enter the selected character.
The cursor shifts rightwards and waits for the
input of the next character.
5
Repeat steps 3 and 4 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat steps 3 and 4 to enter the
correct character.
To erase a character
Press 0 or ) until the character to be erased starts
flashing, then press EDIT/NO.
To enter a space
Press AMS or ) while the cursor is flashing.
6
Press YES.
This completes the labeling procedure and the
title appears on the left side of the display.
To cancel labeling
Press p.
Note
You cannot label a track or an MD while you are recording
over an existing track.
(Continued)
35 EN