Marking Track Numbers While Recording (Track Marking) - Sony MXD-D1 Operating Instructions Manual

Recording on MDs
6
Adjust the balance of the sound sources you want
to record.
Turn MIX BALANCE according to the sound
sources you have selected in the following ways:
If you have selected Turn MIX BALANCE
LINE and CD
MIC and CD
MIC and LINE
When selecting only one sound source
Adjust MIX BALANCE at the center.
7
Do steps 3 to 6 in "Adjusting the Recording
Level" on page 27.
To stop recording
Press p.
When you finish mixing
Disconnect the microphone and adjust MIX BALANCE at
the center.
28 EN
Counterclockwise to raise the
level of the sound source
connected through the LINE
(ANALOG) IN jacks and
clockwise to raise the level of the
CD.
Counterclockwise to raise the
level of the microphone and
clockwise to raise the level of the
CD.
Counterclockwise to raise the
level of the microphone and
clockwise to raise the level of the
sound source connected through
the LINE (ANALOG) IN jacks.
Marking Track Numbers while
Recording (Track Marking)
You can mark track numbers either manually or
automatically. By marking track numbers at specific
points, you can quickly locate those points afterwards,
using the AMS function or editing functions.
r REC
§
· P p
Marking track numbers manually
(Manual Track Marking)
You can mark track numbers at any time while
recording on an MD.
Press r REC at the point you want to add a track mark
while recording.
Marking track numbers automatically
(Automatic Track Marking)
The player adds track marks differently in the
following cases:
• When recording digitally from the CD player section:
The player automatically marks track numbers in the
same sequence as the original CD.
• Other cases
When "LEVEL-SYNC" appears in the display, the
player marks a new track number whenever the
input signal from the sound source is continuously at
or below a certain level for several seconds, and then
exceeds that level (Automatic Track Marking).
If "LEVEL-SYNC" does not light up, set the
LevelSync to ON as follows:
EDIT/NO
§
≠ AMS ±
• •
0 )
YES