Hatco Glo-Ray GRSDH Series Installation And Operating Manual page 18

OPTIONS AND ACCESSORIES
4" (102 mm) Adjustable Legs
NOTICE
Do not lay unit on the side with the control panel or
damage to unit could occur.
Carefully lay unit on its side. Install legs to bottom of unit. Hand-
tighten legs until snug. Do not over-tighten. Return unit to the
upright position.
Leg Adjustment
Shorten
Lengthen
Leg Installation
NOTE: Legs are adjustable for leveling the unit. Use
a 5/8" (16 mm) open-end wrench to make leveling
adjustments once the unit is placed in final position.
Stainless Steel End Panels
Stainless steel end panels are factory installed options in place
of the glass end panels.
Flip-Up Door Locking Plates
Flip-up door locking plates are factory installed and are
available as options for GRSDS-XX, GRSDS-XXD, and
GRSDS-XXT models. Flip-up door locking plates allow access
to the server side only.
Halogen Display Lights
Optional halogen display light bulbs can be ordered in place of
the standard 120 V incandescent display light bulbs.
Divider Rods
Additional divider rods are available to help keep product
separate in the channels.
12" Shelf Height Spacing
(GRSDH-XXD Models Only)
12" shelf height spacing is available as a factory installed
option in lieu of standard 7-1/8" (181 mm) shelf height spacing.
It is available for GRSDH-XXD models on the top shelf only.
Flip-Up Doors
Flip-up doors are available as accessories for all models. The
doors can be installed to each shelf on either the customer
side or operator side of the unit. Use the following procedure to
install flip-up doors (the procedure is the same for either side
as well as each shelf).
NOTE: Units 52" (1321 mm) and larger require 2 doors per
shelf and a center mounting bracket.
1. Remove the two screws from the element end cover above
the desired shelf on each side of the unit.
2. Align the holes on the mounting brackets with the screw
holes on the element end covers of the unit.
3. Insert the screws removed in step 1 through the mounting
brackets and into the unit. Tighten securely.
NOTE: For units 52" (1321 mm) and larger, a center mounting
bracket is required. Remove the screws from the center
of the middle or top housing and use them to mount the
center mounting bracket.
4. Place a spacer on each hinge screw (both included with
door).
5. Align the screw holes at each end of the channel on the
flip-up door with the hole on each mounting bracket.
6. Insert a hinge screw with spacer through each mounting
bracket and into the flip-up door.
7. Tighten the hinge screws until the flip-up door is secure.
Make sure the spacers on the hinge screws go through
the holes in the mounting brackets. Do not over-tighten the
screws.
End
Cover
Mounting
Bracket
End
Cover
Screw
End Cover
Screw
Flip-Up Door Installation
18
English
Mounting
Bracket
Flip-Up
Spacer
Door
Hinge
Screw
Form No. GRSDM-0917