Nibe F1345 Manual page 4

GOOD TO KNOW ABOUT NIBE F1345
Transport and storage
F1345 should be transported and stored vertically in a dry place.
When being moved into a building, F1345 may be leant back 45°.
NOTE! The heat pump is top heavy.
If the cooling modules are pulled out and transported upright,
F1345 can be transported on its back.
The side panels can be removed for easier installation in the
building.
NOTE! Ensure that the heat pump cannot fall
over during transport.
Drawing out the cooling module
To simplify transport and service, the heat pump can be separated
by pulling the cooling module out from the cabinet.
See the installer manual for comprehensive instructions about the
separation.
4 NIBE F1345
Assembly
• Position F1345 on a firm base that can take the weight,
preferably on a concrete floor or foundation. Use the heat
pump's adjustable feet to obtain a stable set-up.
• Install with its back to an outside wall, ideally in a room
where noise does not matter, in order to eliminate noise
problems. If this is not possible, avoid placing it against a
wall behind a bedroom or other room where noise may be
a problem.
• Wherever the unit is located, walls to sound sensitive rooms
should be fitted with sound insulation.
• Route pipes so they are not fixed to an internal wall that
R 0
backs on to a bedroom or living room.
Installation area
Leave a space of 800 mm in front of the heat pump.
Approximately 50 mm free space is required on each side
in order to open the side hatches. The hatches do not need
to be opened during service, all service on F1345 can be
carried out from the front. There must be at least 300mm of
free space above the heat pump. Leave space between the
heat pump and wall behind (and any routing of supply cables
and pipes) to reduce the risk of reproduction of any vibration.
* A normal installation needs 300 - 400 mm (any side) for connection
equipment, i.e. level vessel, valves and electrical equipment.
*
(50) (50)
800
H o t w a te r 5 1 °C H M flo w 4 9 (5 0 ) °C
-2 0 + 2
0 1
R
*