Installation Instructions; Step 1 Remove Packaging; Step 2 Reverse Door Swing - Monogram ZDWI240 Installation Instructions Manual

STEP 1 REMOVE PACKAGING

• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
• Remove stainless steel toekick taped to the back
of the unit.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
AVERTISSEMENT
Les petits objets peuvent étrangler les
enfants. Il faut jeter toutes les piéces qui ne sont pas
utilisées.

STEP 2 REVERSE DOOR SWING

SKIP THIS STEP IF DOOR SWING SUITS THE
INSTALLATION
Parts Included:
• Top left case hinge
• Bottom left case hinge
• Left and right side decorative hinge cover
• Decorative hinge screw hole cover
• Torx driver bit
®
Tools Required:
• Phillips screwdriver
• Electric drill
Remove the door:
• Flatten the shipping carton to use as a pad.
• Remove the 2 screws and the toekick. Set aside the
• Use the supplied Torx bit and electric drill to remove
®
hinge. (Screws will be used to install the new hinge.)
• Remove the bottom case hinge pin and bracket.
Rotate the door:
The handle will be on the right side of the door; hinges
will be installed on the left side of the case.
• Remove the door stop and cam riser on the original
bottom right side of the door.
new left side.
Reinstall the door:
• Install the original door stop and cam riser onto the
bottom left side of the door.
• Install the new supplied bottom case hinge pin and
bracket onto bottom left side.
• Place the door onto the bottom case hinge.
• Install the supplied left-hand top case hinge with the 3
original screws.
• Select the hinge cover marked with an "L".

Installation Instructions

6
STEP 2 REVERSE DOOR SWING (Cont.)
cover.
• Press and snap the hinge cover
into place.
• Snap the screw hole cover into
place on the opposite side.
IMPORTANT:
Check to be sure screws are tight
and that the door is straight and does not sag. The door
should swing freely.
Install
3 Hinge
Screws
Door Stop
and Cam Riser
Install Toekick
The toekick has a
cutout on the left
and right sides.
Remove the plug
on the left side
and reinstall on
the right side.
If you choose
to install the
stainless steel
toekick, reinstall
the plug on the
right side of that toekick.
• Install original screws and spacers or screws and
spacers supplied with the stainless steel toekick. Install
the base as shown.
Install Covers
Remove
Top Hinge
Hinge
Pin and
Bracket
Remove
Hinge