Hitachi PLC Getting Started page 13

n EH-150
Configure baud rate for communication port 1 and 2. For normal use, set the dip switch 1, 3, 5 all
ON, and the toggle switch ON. Both ports will then be available for programming with 19.2kbps.
Toggle switch
Dip switch
Dip switch and toggle switch configuration
RUN/STOP Remote
Mode
RUN switch
Port 1 Dedicated port
(Programming / HMI)
General purpose port
Port 2 Dedicated port
(Programming / HMI)
SW1-6 = Dip switch, SW T = Toggle switch
Baud rate for PC (Programming software)
The baud rate setting procedure depends on the programming software.
Pro-H
Ladder Editor for Win.
CPU module
19.2 kbps for both ports
Dip switch 1, 3, 5 : ON
Toggle switch : ON
SW 1 : ON
SW 1 : OFF
SW 5 : ON
SW 5 : OFF
Right mouse click on "Resource" - [Setting] – [Communication]
[Utility] – [Environment] – [Communication]
OFF
4,800 bps
9,600 bps
19,200 bps
38,400 bps
Modem mode
Normal mode
4,800 bps
9,600 bps
19,200 bps
38,400 bps
12
ON
OFF
8
7
6
5
ON
4
3
2
1
SW 3, 4 : ON, ON
SW 3, 4 : OFF, ON
SW 3, 4 : ON, OFF
SW 3, 4 : OFF, OFF
SW 2 : ON
SW 2 : OFF
SW 6, T : OFF, OFF
SW 6, T : ON, OFF
SW 6, T : OFF, ON
SW 6, T : ON, ON