Installation - Wall Mount - Ronbow SIGNATURE Series Installation And Care Manual

UNITY
Vanity
Model :
E042031
E042047

INSTALLATION - WALL MOUNT

Step 1:
Determine the ideal location of your
new vanity.
NOTE: the location needs at least two
studs. Front notch the studs and install
the 2x6 horizontal beam 30-3/4" from
the floor.
Step 2:
Install the wall brackets to the wall and
fasten with the hex bolts.
Place the metal caps over the
bolt heads.
See Figure 1.
Step 3:
Cut a rough opening for an electrical
box to hard wire to the house.
Step 4:
Remove the drawer.
Refer to page 5.
Step 5:
Slide the vanity over the wall brackets
and secure the brackets to the vanity
with short screws.
See Figure 2.
Step 6:
It is highly recommended to attach the
vanity to the wall using wood screws
to prevent vanity from shifting
over time.
Step 7:
Re-install the drawer.
Refer to page 5.
INSTALLATION SHEET
Figure 1.
Figure 2.
ronbow.eu | ronbow.com
Designed By: KURZ KURZ DESIGN | GERMANY
2
161020