Troubleshooting; Specifications - Sony CDP-C460Z Operating Instructions Manual

Sony compact disc player operating instructions cdp-ce515, cdp-c460z
Hide thumbs Also See for CDP-C460Z:
Table of Contents

Advertisement

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the LINE OUT
LEVEL +/– buttons on the remote.
The CD does not play.
/There's no CD inside the player ("–NO DISC–"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 26).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 26).
/Place the CD in the correct position on the disc
tray.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
/Set the CD 1/2/3 switch on the remote
according to the position of the COMMAND
MODE selector at the rear panel of the player.
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Additional Information
Additional Information
Additional Information

Specifications

Compact disc player
Laser
Semiconductor laser ( = 780 nm)
Emission duration: continuous
Laser output
Max 44.6 W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ±0.5 dB
Signal-to-noise ratio
More than 107 dB
Dynamic range
More than 98 dB
Harmonic distortion
Less than 0.0035%
Output
Jack
Maximum
type
output
level
LINE OUT
Phono
2 V
jacks
(at 50 kilohms)
DIGITAL OUT
Optical
–18 dBm
(OPTICAL)
output
connector
PHONES
Stereo
10 mW
phone jack
General
Power requirements
Where purchased
Power requirements
USA/Canada
120 V AC, 60 Hz
Europe
220 V – 230 V AC, 50/60 Hz
Australia
240 V AC, 50/60 Hz
Power consumption
14 W
Dimensions (approx.)
430
120 393 mm
(w/h/d)
(17
4 3/4
parts
Mass (approx.)
5.4 kg (11 lbs 15 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Wave length: 660 nm
32 ohms
15 1/2 in.) incl. projecting
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdp-ce515

Table of Contents