Troubleshooting; Specifications - Sony CDP-C360Z Operating Instructions Manual

Sony compact disc player operating instructions
Hide thumbs Also See for CDP-C360Z:
Table of Contents

Advertisement

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the LINE OUT
LEVEL +/– buttons on the remote.
The CD does not play.
/There's no CD inside the player ("no dISC"
appears). Insert a CD.
/Place the CD with the label side up on the disc
tray correctly.
/Clean the CD (see page 22).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 22).
/Place the CD in the correct position on the disc
tray.
The remote does not function.
/Remove the obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
/Set the CD 1/2/3 switch on the remote
according to the position of the COMMAND
MODE selector at the rear panel of the player.
The player functions incorrectly.
/The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Additional Information
Additional Information
Additional Information

Specifications

Compact disc player
Semiconductor laser ( = 780 nm)
Laser
Emission duration: continuous
Max 44.6 W*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio
More than 102 dB
Dynamic range
More than 98 dB
Less than 0.0045%
Harmonic distortion
Output
Jack
Maximum
type
output
level
LINE OUT
Phono
2 V
jacks
(at 50 kilohms)
General
Power requirements
120 V AC, 60 Hz
Power consumption
14 W
Dimensions (approx.)
430 120
(17
4 3/4 15 1/2 in.) incl. projecting
(w/h/d)
parts
5.4 kg (11 lbs 15 oz)
Mass (approx.)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
393 mm
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdp-ce415

Table of Contents