Setting Up Your Polybox - Polymaker PolyBox Operation Manual

SETTING UP YOUR POLYBOX

1
To install the hygrometer battery
Slide down the hygrometer battery cover.
Remove the battery from the package, insert
it in the designed compartment and put back
the cover.
Check if the front display switches on. When
you notice that the hygrometer display is
fading, replace the button battery 1.5V LR44.
Note: The provided battery will last
approximately 3 months.
2
To install the rods
Slide two bearings onto both ends of the steal
rod, then snap the rod and bearings into the
PolyBox
TM
To install the desiccant sachets
3
Remove the set of desiccants from the
package and check if the sealed bag is intact.
If there are any leaks, please dry the sachets
before using it. The provided desiccant bags
can be dried in a microwave for 4 times 5min
(defrost mode), make sure to flip the bags
upside down between each iteration. Use
oven mitts to touch the desiccant bags.
Note: other types of desiccant may not have
the ability to recover and be reused.
Do not expose the desiccant sachets to the
air for too long. We highly recommend silica
gel for the type of desiccant.
Put the two desiccant bags into the PolyBox™,
one in each compartment.
Close the two compartments with the two
grids.
TM
10