Advertisement
Thank you for purchasing the PolyBox
absorbing moisture such as extreme oozing, rough surface quality, weaker 3D prints, 3D printer damages and so on!
PACKAGE CONTENTS
Your PolyBox
package should contain the following:
TM
PolyBox
TM
(cover + base)
ESSENTIAL PARTS OF THE POLYBOX
Base
1
2
Cover
3
Rubber Plugs
4
Desiccant Compartments
5
Thermo-Hygrometer
POLYBOX
Operation Manual
from Polymaker! With PolyBox
TM
Front Grid
x 1
Back Grid
x 1
TM
www.polymaker.com
TM
you'll experience no more 3D printing problems caused by filaments
TM
Rods
100g Silica
Gel Sachets x 4
x 4
26.1
C
15
%
Rubber Plug
Thermo-Hygrometer
x 6
x 1
Battery LR44
Filament Guide
x 1
150cm
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Polymaker POLYBOX
Summary of Contents for Polymaker POLYBOX
- Page 1 POLYBOX Operation Manual Thank you for purchasing the PolyBox from Polymaker! With PolyBox you’ll experience no more 3D printing problems caused by filaments absorbing moisture such as extreme oozing, rough surface quality, weaker 3D prints, 3D printer damages and so on!
- Page 2 Note: The provided battery will last approximately 3 months. To install the rods Slide two bearings onto both ends of the steal rod, then snap the rod and bearings into the PolyBox To install the desiccant sachets Remove one set of desiccants from the package and check if the sealed bag is intact. If there are any leaks, please dry the sachets before using it.
Need help?
Do you have a question about the POLYBOX and is the answer not in the manual?
Questions and answers