Sony SRS-XB01 Help Manual page 15

Perform the pairing procedure on the BLUETOOTH device to detect the speaker.
3
When a list of detected devices appears on the display of the BLUETOOTH device, select "SRS-XB01."
*
If a passkey is required on the display of the BLUETOOTH device, enter "0000."
*
The passkey may be called a "passcode," "PIN code," "PIN number," or "password."
Make the BLUETOOTH connection from the BLUETOOTH device.
4
When the BLUETOOTH connection is established, the power/BLUETOOTH indicator switches from flashing to a
steady state.
If the BLUETOOTH connection is not established, repeat from step
Hint
Once the BLUETOOTH function is activated on the BLUETOOTH device which has been connected to the speaker via a
BLUETOOTH connection, the BLUETOOTH device is connected to the speaker again by just pressing the
PAIRING button.
For details on operating a BLUETOOTH device, refer to the operating instructions supplied with the BLUETOOTH device.
Note
The pairing mode of the speaker is released after about 1 minute and the power/BLUETOOTH indicator flashes slowly. However,
when pairing information is not stored in the speaker, such as at the factory settings, the pairing mode is not released. If the
pairing mode is released before finishing the process, repeat from step
The passkey of the speaker is "0000." If a passkey besides "0000" is set on the BLUETOOTH device, pairing cannot be done with
the speaker.
Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:
Pairing information has been deleted after repair, etc.
The speaker is already paired with 8 devices and another device is to be paired.
.
.
15
(power)/