Ryobi RPHT254O Original Instructions Manual page 18

OPERATION
STARTING A WARM ENGINE BY ELEC-
TRICAL STARTER
1. Install the starter bit into the electrical
starter with the pentagon bit facing
outside. Push the F/R button to the left
until the pentagon symbol shows on the
F/R button.
2. Insert the battery pack into the electrical
starter until it clicks into place.
WARNING: Keep your hands away from
the starter bit to avoid injury.
3. Lay the product on the ground and make
sure that the cutting means does not
come in contact with anything. Press the
primer bulb 10 times.
Set the choke lever to
16
1
2
position.
3
2
1
x10
1
2