Ryobi RPHT254O Original Instructions Manual page 16

OPERATION
STARTING A COLD ENGINE BY ELEC-
TRICAL STARTER (OPTIONAL)
WARNING: Only use RYOBI OES18
electrical starter. Use of any other starts
may damage the engine and cause serious
personal injury.
WARNING: Before using the electrical
starter to start the product, please read
and understand completely the operation
manual of the OES18 electrical starter
to avoid improper operation and serious
personal injury.
1. Install the starter bit into the electrical
starter with the pentagon bit facing
outside. Push the F/R button to the left
until the pentagon symbol shows on the
F/R button.
2. Insert the battery pack into the electrical
starter until it clicks into place.
WARNING: Keep your hands away from
the starter bit to avoid injury.
3. Lay the product on the ground and make
sure that the cutting means does not
come in contact with anything. Press the
primer bulb 10 times.
NOTE: After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the fuel is
visible.
Set the choke lever to
14
1
2
3
choke position.
2
1
x10
1
1
2