GAI-Tronics 670-001 Manual

GAI-Tronics 670-001 Manual

Explosion-proof speaker station

Advertisement

Quick Links

Explosion-proof Speaker Station

Confidentiality Notice

This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.

General Information

The Model 670-001 Explosion-proof Speaker Station provides safe and clear communications in
hazardous areas, even in high-noise situations. This model is NRTL certified for use in the US and
Canada for the following areas: Class I, Div. 1, Groups C and D; Class II, Div. 1, Groups E, F, and G; and
Class III, Div. 1.
The Model 670-001 station enclosure is fabricated from cast aluminum and is suitable for indoor use. If
the station is to be mounted outdoors, it should be housed in a GAI-Tronics Model 10444-003
Weatherproof Non-metallic Enclosure. This enclosure is rated NEMA 4X, and can be purchased
separately.
This installation manual provides instructions on both the placement and mounting of the stations. Refer
to Pub. 42004-185 and 42004-237 (Canada), which show the conduit installation and station wiring
details necessary to maintain the explosion-proof integrity of the station.
WARNING
Explosion Hazard – Do not connect or disconnect equipment unless power
has been switched off or the area is known to be non-hazardous.
Installation
Whether installing an entire system or only an add-on station, consult the system layout diagrams at the
end of this manual. These figures, used in conjunction with the station installation information and the
cable layout guide, should provide all the information necessary to install the Page/Party
figures do not show an explosion-proof station; however, the basic points of the system layout and design
still apply.
NOTE
A separate power feed is recommended for Page/Party
a separate power feed, the Page/Party
disrupting the power supply to the other equipment in the Div. 1 area.
GAI-TRONICS 3030 KUTZTOWN RD. READING, PA 19605 USA
610-777-1374
V
ISIT WWW
G A I - T R O N I C S ®
A H U B B E L L C O M P A N Y
Model 670-001
®
stations can be shut off for service or maintenance without
800-492-1212
.
-
.
GAI
TRONICS
COM FOR PRODUCT LITERATURE AND MANUALS
®
stations in Div. 1 areas. With
Fax: 610-796-5954
Pub. 42004-161D
®
stations. These

Advertisement

Table of Contents
loading

Summary of Contents for GAI-Tronics 670-001

  • Page 1: Confidentiality Notice

    Canada for the following areas: Class I, Div. 1, Groups C and D; Class II, Div. 1, Groups E, F, and G; and Class III, Div. 1. The Model 670-001 station enclosure is fabricated from cast aluminum and is suitable for indoor use. If the station is to be mounted outdoors, it should be housed in a GAI-Tronics Model 10444-003 Weatherproof Non-metallic Enclosure.
  • Page 2 NOTE If this unit is to be used outdoors, it should be mounted inside a GAI-Tronics Model 10444-003 Weatherproof Non-metallic Enclosure, which is equipped with a front door. This enclosure has four mounting feet in the four corners and is suitable for mounting to many surfaces. It can be purchased separately.
  • Page 3 Pub. 42004-161D Model 670-001 Explosion-proof Speaker Station Page: 3 of 8 Figure 1. Model 670-001 Mounting Details \\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-161d.doc 03/04...
  • Page 4: Conduit Installation

    Feed the wiring through the conduit and into the enclosure. Follow the wire colors carefully—these colors correspond to GAI-Tronics 60029 or 60038 Series cable. The wires must be spade-lugged and connected carefully and completely to the terminal block. An improper termination may result in diminished station performance.
  • Page 5 Mutual muting can be accomplished between the Div. 1 stations and Div. 2 enclosures using most GAI-Tronics 600 or 700 Series enclosures by connecting the orange (spare) wire between TB2-11(A) on the Div. 1 station and TB1-7 on the Div. 2 enclosure: Div.
  • Page 6: Specifications

    Pub. 42004-161D Model 670-001 Explosion-proof Speaker Station Page: 6 of 8 Specifications Power input ............90–140 V ac; 120 V ac nominal, 50–60 Hz; 0.5A maximum Dimensions .............13.1 H × 7.9 W × 5.6 D inches (332 × 200 × 143 mm) Temperature range................
  • Page 7 Pub. 42004-161D Model 670-001 Explosion-proof Speaker Station Page: 7 of 8 \\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-161d.doc 03/04...
  • Page 8 Pub. 42004-161D Model 670-001 Explosion-proof Speaker Station Page: 8 of 8 \\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-161d.doc 03/04...
  • Page 9: Warranty

    Warranty Equipment. GAI-Tronics warrants for a period of one (1) year from the date of shipment, that any GAI-Tronics equipment supplied hereunder shall be free of defects in material and workmanship, shall comply with the then-current product specifications and product literature, and if applicable, shall be fit for the purpose specified in the agreed-upon quotation or proposal document.

Table of Contents