System Operation - Audio Technica M3 Setup And Operation

How to install the batteries in your M3R Stereo Receiver

System Operation

Placement:
Location
System set-up:
1.
2.
3.
minimum position Note: At this point, check to be certain the
RF indictor is not illuminated. If it is illuminated before you
have powered on the transmitter, this means the frequency
you have chosen is already in use. Choose another frequency.
4.
5
See page 17 . Note: Do not set more than
one transmitter to the same frequency.
6.
7.
All manuals and user guides at all-guides.com
with volume in
1.
2.
3.
Note:The M3R Stereo Receiver's "fuel gauge" battery indicator
displays a maximum of four bar segments. When it flashes
"LOW.BAT" , the batteries should be replaced immediately to
ensure continued operation.
Audio set-up:
8.
audio signal through your transmitter (to another transmitter
or recording device, for instance), use the Loop output connectors
on the back of the M3T Stereo Transmitter.The R/2 XLR jack
duplicates the unprocessed signal of the R/2 input; the L/1 XLR
jack duplicates the unprocessed signal of the L/1 input.These
are not affected by front panel settings.
9.
10.
11.
See page 12.
12.
NOTE: Do not put the earphones in your
ears at this point.
13.
14.
Note: If you want to send the
minimum position
minimum position