Bunn Soft Heat Use & Care Instructions

Brewing Coffee
Insert a BUNN filter into a
clean brew funnel.
Gently shake funnel to
spread the grounds evenly.
Press the assigned BREW
button (A, B, or C).
Cleaning the Brewer (DAILY)
Every Day: Clean the
spray head panel and the
entire outside surface of
the brewer with paper
towels and an approved
multi-surface cleaner.
53431.0002 D 01/18 ©2017 Bunn-O-Matic Corporation
If using pre-ground coffee,
simply pour fresh coffee
into filter.
Slide the funnel into the
funnel rails of the brewer.
The display will read
NOW BREWING with the
remaining brew time.
Remove the sprayhead
by turning in a counter-
clockwise direction.
Soft Heat
If grinding fresh coffee,
place funnel in grinder.
Rotate server handle forward
to lock the lid. Place empty
server under the funnel.
The word DRIPPING will
read on the display.
Grasp sprayhead with a
clean sanitized cloth and turn
counter-clockwise to remove.
Disassemble and thoroughly
wash, rinse, and sanitize the
sprayhead. The holes must be
open and clear of any mineral
deposits.
Page 1 of 2
Brewer & Server
®
Use & Care Instructions
For two hopper grinders,
select coffee type by
pressing "RIGHT" or
"LEFT" hopper.
Press and release the
"ENABLE BREW" button.
When dripping has stopped,
discard the used grounds
and filter. Rinse the funnel
and server after each use.
Wash hands and put
on single use gloves.
Re-assemble the
sprayhead and install
it onto the brewer.
Press the GRIND button to
fill the funnel.
Press the Batch Size button
according to the amount of
coffee in the filter.
Cleaning the Funnel
(DAILY)
Clean the funnel with wash
solution, rinse, and sanitize
for 60 seconds using an
approved sanitizer.
Cleaning the Brewer
(WEEKLY)
Use the long end of the
sprayhead cleaning tool
to clean the sprayhead
outlet fitting.