Advertisement
15. Do not use the Ball Joint Kit to compress
springs or any other item that could
disengage and cause a potential hazard.
16. Do not allow any lubricants to make contact
between any part of the Ball Joint Kit and the
part being pressed. Lubricants of any type on
the above mentioned parts will diminish the
ability of the Ball Joint Kit to firmly and safely
grip and hold the Ball Joint Kit in position.
17. Examine the Ball Joint Kit for structural cracks,
bends, and any other condition that may affect
the safe operation of the tool. Do not use the
Ball Joint Kit even if minor damage appears.
Operating Instructions
Read the ENTIRE WARNING section at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Note: Read vehicle service manual to determine how to prepare the ball joint for removal from a specific
vehicle make/model. The generic instructions that follow may, or may not apply to your vehicle.
To Remove a Ball Joint
1. Assemble the Ball Joint Press (1) over the
vehicle's control arm. Select the correct
size Receiving Tube (3, 4, or 5), and
position it under the vehicle's ball joint.
2. Place the Removal Adapter (7) between the
Receiving Tube and the Jackscrew (2).
3. Then, place the Installation Adapter (6)
between the top of the ball joint and the
Ball Joint Press. See Figure A.
4. Tighten the Jackscrew until the Receiving Tube
contacts the vehicle's control arm.
5. Check the alignment of all the Ball Joint Kit parts,
and continue tightening the Jackscrew until
the vehicle's ball joint is removed.
Item 62849
SAVE THESE INSTRUCTIONS.
For technical questions, please call 1-888-866-5797.
18. Read and understand all instructions and safety
precautions as outlined in the manufacturer's manual
for the vehicle you are servicing. Use the vehicle
manufacturer's recommended ball joint press points.
19. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
Installation
Adapter (6)
Ball
Joint
Control
Arm
Receiving
Tube
(3, 4 or 5)
Removal
Adapter (7)
Ball Joint
Press (1)
Jackscrew (2)
Figure A
Page 3
Advertisement
