Troubleshooting; Soft Reset; Reset Pairing; Reset To Factory Settings - Cardo Systems FREECOM 4+ Manual

5. TROUBLESHOOTING

5.1 SOFT RESET

If your FREECOM 4+ stops responding, reset it in one of these ways:
Turning it off and then on again (see
●
Using the supplied USB cable, connect your unit to the computer or wall charger for 30 seconds.
●

5.2 RESET PAIRING

The options below delete all paired units or devices.
To reset mobile device pairing:
1. While in standby mode, press
The LED flashes red and blue.
2. Press and for 2 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
To reset intercom pairing:
1. While in standby mode, press
The LED flashes red
2. Press and for 2 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.

5.3 RESET TO FACTORY SETTINGS

This option deletes all paired units, devices and all configuration settings.
To perform a factory reset through the unit:
1. Check that your FREECOM 4+ is in Standby mode (see
2. Simultaneously press
The LED flashes purple 5 times slowly, confirming that pairing has been reset.

5.4 FAQ

Additional answers to common problems can be found at www.cardosystems.com/support.
Getting Started
for 5 seconds.
for 5 seconds.
+ + for 5 seconds.
on page 5).
FREECOM 4+ LED Indications
17
on page 22).