Advertisement
Quick Links
Moog Components Group
VIDEO 3 Input/Output Boards
February 24, 2009
Video 3 Input/Output Boards
Users' Manual
And
Troubleshooting Guide
February 24, 2009
Rev. E
Moog Components Group
Springfield Operations
750 West Sproul Road
Springfield, PA 19064
E-Mail:
mcg@moog.com
URL:
www.moog.com/components
Tel: 610-328-4000 Fax 610-605-6216
24/7 Technical Customer Support Hotline: 610-605-6101
Page 1 of 7
Advertisement
Summary of Contents for PRIZM Video 3
-
Page 1: Troubleshooting Guide
Moog Components Group VIDEO 3 Input/Output Boards February 24, 2009 Video 3 Input/Output Boards Users’ Manual Troubleshooting Guide February 24, 2009 Rev. E Moog Components Group Springfield Operations 750 West Sproul Road Springfield, PA 19064 E-Mail: mcg@moog.com URL: www.moog.com/components Tel: 610-328-4000 Fax 610-605-6216... - Page 2 VIDEO 3 Input/Output Boards February 24, 2009 Video 3 Board ............................3 Video 3 Board Revision History: ..................... 3 Video 3 Board Dash (-) Number Definitions: .................. 4 Video 3 Board Operation: ........................ 5 1.3.1 Video 3 Board Indicator and Controls:................... 5 1.3.2...
- Page 3 There are two versions of the Video 3 boards, in input and an output board, and they are used in conjunction with each other at opposite ends of the link. 1.1 Video 3 Board Revision History:...
- Page 4 PCB Revision B/Assembly Revision C Currently in production. 1.2 Video 3 Board Dash (-) Number Definitions: The Video 3 board has a Dash Number appended to the part number. This Dash Number identifies the specific board configurations: Video 3 Input boards:...
- Page 5 The video channels are unidirectional and the direction depends on whether the board is a Video 3 Input or Output. Video 3 boards work in pairs of one input and one output board. When using multiple pairs, proper board pair addressing is critical. Surface unit Video board #1 must be configured to work with the sub-sea unit’s Video board #1 and surface...
- Page 6 If one or more video channels are tearing or have low video level: • Adjust the gain on Video 3 Input board to a 1 to 1 gain, utilizing trimpots VR1 - VR4. Access to these trimpots is through the front panel of the board, next to the yellow LEDs.
- Page 7 ROV.) • Verify that Video 3 board address dip switch is correctly set for BD1 or BD2 and that the surface and ROV ends of the link are set identically.