Advertisement
Moog Components Group
1 Video 3 Board
Part Number -200460-xxx (Input) -200470-xxx (Output)
are two versions of the Video 3 boards, in input and an output board, and they are used in
conjunction with each other at opposite ends of the link.
1.1 Video 3 Board Revision History:
The Video 3 Input board has gone through the following printed circuit board (PCB) and
Assembly revisions:
PCB Revision A/Assembly Revision A Original design. Not currently in production.
PCB Revision B/Assembly Revision A-C Corrected PCB layout and component values
errors.
PCB Revision B/Assembly Revision D Modified resistor values to improve video clamp
circuit.
PCB Revision B/Assembly Revision E Modified resistor values to improve video clamp
circuit. Currently in full production.
The Video 3 Output board has gone through the following printed circuit board (PCB) and
Assembly revisions:
PCB Revision A/Assembly Revision A Original design. Not currently in production.
VIDEO 3 Input/Output Boards
Page 3 of 7
February 24, 2009
The Video 3 board supports
four 10-bit digitized video
channels. Unlike the earlier
Video 1 and Video 2 Video
boards, there are NO data
channels physically on this
board and thus there are no
ribbon
cable
connectors.
Also, unlike the Video 1 and
Video 2 boards, the Video 3
board does not require a video
sync in the signal to operate,
thus it can be configured for
passing analog data.
There
Advertisement
