Table of Contents
Advertisement
Disassembly
Removing the System Memory (RAM)
Figure 6
RAM Module
The computer has two memory sockets for 200 pin Small Outline Dual In-line Memory Modules (SO-DIMM) supporting
Removal
DDR 400 MHz. The main memory can be expanded up to 2GB. The SO-DIMM modules supported are 256MB, 512MB
and 1024MB DDR Modules. The total memory size is automatically detected by the POST routine once you turn on your
a. Remove the screws.
computer.
b. Lift off the bay cover.
c. Pull
the
release
Memory Upgrade Process
latch(es).
1. Turn off the computer, and turn it over and remove the battery
d. Remove
the
mod-
ule(s).
2. Locate the memory (RAM) bay cover and remove screws
3. Carefully (the fan cable will still be attached) lift off the bay cover
4. Gently pull the two release latches
arrows
Contact Warning
5. The RAM module
6. Pull the latches to release the second module if necessary.
Be careful not to touch
7. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
the metal pins on the
module's
connecting
8. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
edge. Even the cleanest
as it will go. DO NOT FORCE IT; it should fit without much pressure.
hands have oils which
9. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
can attract particles, and
10. Replace the memory (RAM) bay cover and the screws
degrade the module's
11. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
performance.
a.
8. RAM Module(s)
b.
• 4 Screws
2 - 10 Removing the System Memory (RAM)
All manuals and user guides at all-guides.com
&
6
(Figure
c).
will pop-up
(Figure
8
c.
1
2
3
4
5
(page 2 -
5).
-
.
1
4
.
5
on the sides of the memory socket in the direction indicated by the
7
d), and you can then remove it.
(Figure
a).
d.
6
7
8
Advertisement
Table of Contents
