System 3000
Relay switching insert
Connecting and fitting the device
Figure 1: Connection diagram with optional extensions
■
Connect the switch insert (2) according to the connection diagram (Figure 1). Note clamp-
able cable cross-sections (Figure 2).
■
Connect the 2-wire extension (3), the 3-wire extension (4) and as an option, the push-but-
ton with NO contact (5).
Lit push-buttons must have a separate N terminal.
■
Fit the switch insert in the appliance box, the connection terminals must be at the bottom.
Do not attach or replace the cover under voltage, otherwise this might cause a malfunc-
tion.
■
Attach the frame and the cover.
■
Switch on mains voltage.
The load can be switched by briefly pressing the TEST button (1).
82597422
Figure 2: Terminal-specific cable cross-section:
06.05.2019
2 / 4