Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
Rigging
The device easily attaches to metal surfaces with its magnetic base (remove clip for this) or to drop ceilings
with its scissor clip. Adjust the desired pan and tilt angles.
Hanging installation
The device has to be installed out of the reach of people.
The device must never be fixed swinging freely in the room.
Caution: Devices may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the device!
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
OPERATION
Battery Operation
The device features a rechargeable lithium battery for cable-free operation. Prior to initial use, completely
charge the battery.
1
Connect the charger to the power input at the device and the mains plug to a mains outlet (100-240 V
AC, 50/60 Hz). The indicator light on the charger turns red while the battery is charging, then it turns
green when the battery is done charging. The battery can be charged before, during or after operation.
To charge the battery with the LED off, leave the power switch in the off position.
2
The device features a protective circuit for charging which prevents overload of the rechargeable battery.
However, disconnect the device from the mains after charging. Otherwise there will be a low current
consumption even if the device is switched off.
3
The device will heat up during charging; this is normal.
4
To prevent damage to the battery by deep discharge, recharge a battery completely discharged as soon
as possible. Do not store the unit with the battery completely discharged and regularly recharge the
battery in case of long storage.
Maximum battery run time
6 hours
DANGER OF FIRE!
Recharge time
5 hours
14/16
00089303.DOC, Version 1.0
Advertisement
Table of Contents
