NovoPress ACO401 Operating Manual page 28

ACO401
6.2 Release button
EN
In the event of an emergency, the pressing operation can be stopped at any time by pressing
and holding release button (6). The piston in the press device then returns to its starting
position.
6.3 Rechargeable battery
6.3.1 Removing the battery (Fig. 2)
Press the two release buttons (A) inwards (1) and then remove battery (2).
6.3.2 Inserting the battery (Fig. 3)
Slide the battery onto the device as illustrated until it clicks in.
6.3.3 Battery level indicator
The battery level is displayed when button (B) is pressed. The number of LEDs lit up denotes
the battery level.
If the battery is inserted in the press device when the battery level is checked, the last pressing
operation must have been completed at least 1 minute prior to this. Otherwise the display will be
inaccurate.
6.4 Press device and rechargeable battery
Feature of the press device after extended periods out of use or when changing the
battery
If the press device is out of use for approx. one hour or the battery is reinserted, it switches to
SLEEP mode. The LED is no longer illuminated. Press the Start button to start the press device.
Feature of the press device when the battery is empty
When a pressing operation begins, a check is made to determine whether the battery charge is
sufficient to complete the pressing operation. If this is not the case the device does not start.
The green LED flashes.
If the green LED flashes following a pressing operation, the pressing operation was carried out
correctly. The battery must be recharged prior to the next pressing operation.
Information!
The ACO 401 press device must only be operated with 3.0 Ah 18 V
lithium-ion rechargeable batteries. The 18 V rechargeable battery must
only be used in the appropriate press devices.
22