Advertisement
2D. Procedure to edit new ATIS
Please read instructions under 2B.2
3. Seagoing Mode and Inland Waterway Mode
The radio can be switched from "Seagoing Mode" to "Inland Waterway Mode".
3A. This is mentioned in the user manual.
Press PA/MODE to switch from mode.
3B. When "WX" blinks in the display the radio is in "Inland Waterway" Mode.
4. Enable 9 extra channels
4A. The radio comes with channels for "Seagoing Mode" and "Inland Waterway
Mode". In some countries channels in the VHF marine band are used that are not in
the standard list of channels. If a user has a license for using these channels he
needs to visit a Uniden Marine Dealer to activate this function.
4B. There are 4 extra modes:
Mode 1
L1/L2/F1/F2/F3
Mode 2
L1/L2/L3/F1/F2/F3
Mode 3
30/31
Mode 4
M1 (display N1)
4C. Procedure to activate extra modes:
1. Make sure radio is off.
2. Press simultaneously SCAN and HI/LO while turning power on.
3. Repeat step 1 and 2 to move to next mode.
4. After mode 4 the radio starts up in original mode again.
Note: Radio always start up in the last selected mode.
5. UIC/ USA – International – Canada
5A. The radio can be switched from not only for Europe from 'Inland Waterways' to
'Seagoing Mode' but also from International to USA and Canada frequency chart.
5B. Procedure to activate UIC:
1. Make sure radio is off.
2. Press simultaneously Select and HI/LO while turning power on.
3. Repeat step 1 and 2 to move to next mode.
Note: Detailed information about the frequencies and channels for the different
modes can be found in the operation specifications
AVF129 V3 / june 7 - 2005
Advertisement
