Fortinet FortiGate Series Install Manual page 24

Configuring transparent mode
22
The following steps add two policies that allows all traffic through the Fortinet unit, to
enable you to continue testing the configuration on the network.
To add an outgoing traffic firewall policy - web-based manager
1 Go to Firewall > Policy.
2 Select Create New.
3 Set the following and select OK.
Source Interface/Zone
Source Address
Destination Interface/Zone
Destination Address
Schedule
Service
Action
Figure 11: Creating an outgoing firewall policy
To add an outgoing traffic firewall policy - CLI
config firewall policy
edit <index_int>
set srcintf <name_str>
set srcaddr <name_str>
set dstintf <name_str>
set dstaddr <name_str>
set schedule always
set service ANY
set action accept
end
To add an incoming traffic firewall policy - web-based manager
1 Go to Firewall > Policy.
2 Select Create New.
3 Set the following and select OK.
Source Interface Select the port connected to the Internet.
Source Address All
Destination Interface Select the port connected to the network.
Destination Address All
Select the port connected to the network.
All
Select the port connected to the Internet.
All
always
Any
Accept
FortiGate Version 4.0 Desktop Install Guide
Configuring
01-400-95522-20090501
http://docs.fortinet.com/ • Feedback