Table of Contents
Advertisement
Using Super cool, Super freeze and DynaCool
DynaCool function
When the DynaCool function is not
switched on, the natural circulation of
air in the appliance will cause different
temperature zones in the refrigerator as
the cold, heavy air will sink to the
lowest section of the appliance. You
should bear this in mind when placing
food in the appliance (see "Storing food
in the refrigerator section").
However, if you are placing a large
amount of food in the refrigerator at any
one time, (e.g. after the weekly shop) it
is a good idea to switch DynaCool on.
This way you can distribute the
temperature inside the appliance to all
areas more evenly so that all the food
will be chilled to about the same
degree.
The temperature is set as normal.
DynaCool should also be selected
when:
– the ambient temperature in the room
is high (above approx. 30 °C), and
– the room humidity level is high.
With DynaCool switched on, the fan is
ready: when the compressor switches
on, the fan also switches on
automatically.
Tip: Because DynaCool requires more
energy, you should switch it off under
normal conditions.
To save energy, the fan switches off
automatically whilst the door is open.
Switching a function on or off
Touch the sensor for the function you
want.
– The display LED next to the
corresponding symbol will light up
and the function will be switched on.
– The display LED next to the
corresponding symbol will go out and
the function will be switched off.
After an interruption to the power
supply any function that was
previously switched on will be
switched off.
29
Advertisement
Table of Contents
