Mounting The Stove - Dometic ORIGO A100 Operating Manual

Dometic ORIGO
7

Mounting the stove

You can fit the stove into the countertop of your kitchen.
7.1 Selecting the installation location
When selecting the installation location, observe the following instructions:
 Select a well-ventilated location for the device.
 Ensure a minimum distance (fig. 6, page 4) of
– 50 mm to side and back walls
– 750 mm between stove coil element and horizontal surface above the
stove
 Avoid draft at the installation location.
If you fit the stove in an open cockpit or other open areas mount an
additional wind protection.
 Avoid cabinet storage space above the stove.
Otherwise you risk burns and fire when reaching over the stove.
 Do not operate the device in spaces where danger of explosion is pre-
sent.
7.2 Installing the stove
NOTICE! Danger of damaging the device!
A
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Cut a rectangular hole into the countertop (dimensions see following
table):
Model
A100
A200
C100
C200
➤ Open the top and remove the canisters (see "Taking out the canister" on
page 17).
➤ Open up the hinge part in the back of the stove.
EN
Dimensions W x D x H
255 x 150 x 340 mm
485 x 150 x 340 mm
255 x 150 x 340 mm
485 x 150 x 340 mm
Mounting the stove
15