General Guidelines; Operating Information - I-care IC222 Operating Manual & Warranty

GENERAL GUIDELINES:

OPERATING INFORMATION

DO NOT use near explosive gases

Keep the product a minimum of 30cm away from any direct heat source

Close supervision is necessary when this product is used by or near children

Check all parts for shipping damage and test before using. In case of damage, DO

NOT use. Contact a qualified technician for further instructions
After any adjustments, repair or service and before use, make sure all attaching hard-

ware is tightened securely.
DO NOT let any individual underneath the bed or in between the raised bed frame

components at anytime.
When the bed is not to be used for an extended period of time, unplug the electric

bed from the wall outlets.
If a liquid is spilled in or around the electric bed, unplug the electric bed before clean-

ing, clean up the spill and allow the electric bed or the area around the electric beds
to dry thoroughly before using the electric controls again.
Body weight should be evenly distributed over the surface of the bed. DO NOT lie, sit

or lean in such a way that your entire body weight is placed only on raised head or
foot sections of the bed.
When operating/moving manual electric beds, always ensure that the individual utilis-

ing the bed is positioned properly within the confines of the bed. DO NOT let any ex-
tremities protrude over the side or between the bed rails when performing these func-
tions.
After the manual/electric bed has been assembled, always test to make sure that all

sections of the manual/electric bed are properly and securely in place before using.
If the unit is not working properly, call a qualified technician to examine the unit and

repair it.
Keep all moving parts, including the main frame, mattress deck (head and foot

springs/sections) and all drive shafts, free of obstruction (i.e. blankets/sheets, heating
blankets/pads, tubing, wiring, etc. and other types of products using electric cords
which may get tangled around the bed, side rails or legs) during operation of manual/
electric bed.
The manual/electric bed is equipped with locking castors. When transferring into or out

of the manual/electric bed, always
for correct locking action before actual use. Even with castors properly locked, some
flooring surfaces such as tile or wood, will allow the bed to move under some condi-
tions. To use on surfaces such as these must be evaluated by the care provider.
the locking castor(s). Inspect the wheel locks
lock