Related Manuals for I-care IC222
Summary of Contents for I-care IC222
- Page 1 IC222 BED SYSTEM OPERATING MANUAL & WARRANTY NEED HELP? CALL OUR TEAM AU: 1800 105 853 | NZ: 0800 143 922...
- Page 2 1. SPECIAL NOTES 2. GENERAL GUIDELINES 3. UNPACKING 4. ASSEMBLY 5. OPERATION 6. HEADBOARD INSTALLATION 7. WARRANTY TERMS...
-
Page 3: Special Notes
SPECIAL NOTES: Signal words are used in this manual and apply to hazards or unsafe practices which could result in personal injury or property damage. Refer to the table below for defini- tions of the signal words. This model meets Australian and New Zealand Standards and is registered by the Thera- peutic Goods Administration. -
Page 4: General Guidelines
GENERAL GUIDELINES: OPERATING INFORMATION DO NOT use near explosive gases Keep the product a minimum of 30cm away from any direct heat source Close supervision is necessary when this product is used by or near children Check all parts for shipping damage and test before using. In case of damage, DO ... - Page 5 UNPACKING: RECEIVING Count cartons before signing shipping papers Designate someone at the facility to receive and inspect all merchandise. Use the master order acknowledgement to check off items as they are received. Compare the number of cartons shipped with the number of cartons actually re- ceived and note such on the consignee copy of the freight bill.
- Page 6 ASSEMBLY: 1: Remove the four castors from package and insert into wheel mounts. In- sert the bolt and washer into the fixing hole and tighten 2: Remove power cord, hand piece and retainer bar from underneath the 3: Insert retainer bar into the holes at the end of bed 4: Move bed into desired position, plug into power.
-
Page 7: Operation
Before placing the bed into use, test it by operating it through all phases of its oper- ation. If any problems arise during the test, recheck all electrical and mechanical connec- tions. IC222 electrical beds use a six function hand piece for all bed operations REMOTE CONTROL Head Raise Head lower... - Page 8 HEABOARD INSTALLATION: STEP ONE: Unpack headboard STEP 2: Place headboard in position (this may require two people) STEP 3: Screw headboard bolts into the holes provided. Tip: screw in the top ones for a start.
-
Page 9: Limited Warranty Terms & Conditions
ICARE IC222 LIMITED WARRANTY TERMS & CONDITIONS Sleep Systems warrants the IC222 Height Adjustable Bed and parts to the Customer against defective materials and defective workmanship, from date of invoice. Steel Frame of Bed - 5 Year Limited Warranty Actuators - 5 Year Limited Warranty... - Page 10 CONDITIONS This warranty covers products where Sleep Systems has established there has been a manufactur- ing or material defect within the warranty period. Sleep Systems will at its discretion either repair or replace the faulty products. The original warranty expiry date will still apply to the repaired or re- placed products.