Table of Contents
Advertisement
DrIvEr CONTrOL FEATUrES
DrIvEr POSITION MEMOrY SYSTEM
The Driver Position Memory System controls
are located on the driver's side door trim.
TO SET THE MEMOrIZED DrIvEr POSITION:
1.
Place the shift lever into P (Park) while the
ignition switch is ON.
2.
Adjust the driver's seat, outside rearview
mirrors and adjustable pedal positions to the
desired position.
3.
Push the M button on the control panel until the signal beeps.
4.
Within five seconds, push button 1 or 2 until the signal beeps twice. The beep
confirms that the positions are successfully memorized.
TO ACTIvATE THE MEMOrIZED POSITION:
1.
Place the shift lever into P (Park) while the ignition switch is ON.
2.
Press button 1 or 2 to adjust seating position to memorized setting.
EASY ACCESS FUNCTION
When the AUTO button is ON (the indicator light illuminates) and the shift lever is
in the P (Park) position, the system will move the driver's seat forward or backward
automatically so you can comfortably enter and exit the vehicle.
See the Owner's Manual for conditions in which the Driver Position Memory System
will not operate.
POWEr SEAT ADjUSTMENT
(if equipped)
LUMBAr CONTrOL
A
To manually adjust the lumbar support, move the lever to
the desired position.
SEATBACK ANGLE
B
To recline the seatback, tilt the control forward or backward.
SEAT HEIGHT AND FOrWArD / BACKWArD
C
To adjust seat cushion height, move the control
switch according to the desired adjustment.
The front and rear sections of the cushion
can be adjusted independently.
To move the seat forward or backward,
move the control switch
accordingly.
C
4
(if equipped)
2
1
M
AUTO
2
1
M
AUTO
POWEr MIrrOr CONTrOL
The switch is located on the driver's door
panel next to the driver position memory
system and can be used to adjust both
the left and right outside mirrors.
TO ADjUST THE POSITION OF EITHEr
MIrrOr:
1.
Move the selecting switch to the
R (right) or L (left) to adjust the
corresponding mirror.
2.
Adjust the mirror angle by
depressing the appropriate direction
on the perimeter switch.
3.
Move the selecting switch to L to tilt
down both mirrors while in reverse.
4.
Move the selecting switch to R to tilt
down only the right mirror.
5.
Move the selecting switch back to
the middle position to deactivate the
perimeter switch.
A
B
C
HEADLIGHTS AND FOG LIGHTS
HEADLIGHT SWITCH
To operate the headlights, turn the
switch on the end of the lever:
OFF
–
Headlights are off
–
Parking Lights
–
Headlights
AUTO –
Auto Light
(if equipped)
NOTE: The ignition must be in the ON
position to turn on the headlights.
High Beam Activation:
Push the
lever forward.
Flash Feature:
Pull the lever toward
you and release.
FOG LIGHT SWITCH
(if equipped)
Turn the switch to the ON position.
NOTE: Fog lights will only function on
low beam.
5
Advertisement
Table of Contents
