Whirlpool GC900QPPQ User Instructions page 7

Preparing for Custom Panel Installation
Front panel screws
Front panel
Panel removal
in this
direction
Foot pedal
1. If installing the longer panel, remove the handle by removing
the three screws.
2. Turn the drawer upside down for this procedure. Do not put
too much pressure on the handle if turning the drawer over.
It is best to place the drawer on a bench or elevated item to
avoid putting pressure on the handle.
3. Remove foot pedal by removing the two screws.
4. Remove toe guard by removing the two screws.
5. Remove the four front panel screws.
6. Slide the front panel out and place aside.
7. Locate the rest tab on the bottom of the drawer front panel.
Handle
Handle
Screws
Foot pedal screws
Toe guard
Toe guard scews
Rest tab
Bend this tab 90 degrees as shown.
Tab orientation as supplied
8. Place the custom panel against the container front and rest
it on the tab.
9. Use 4 #8 x 1" wood screws to attach the custom panel as
shown below. If you are installing the long panel (handle
removed) you will have three holes available, for a total of
seven screws to attach the custom panel.
10. Long Panel Only: A 3/4" quarter round molding with the
following dimensions is suggested to fill the gap left by the
removed handle.
0.75"
0.75"
(19 mm)
(19 mm)
0.63"
0.63"
(16 mm)
(16 mm)
11. Reattach the toe guard with the two screws.
12. Reattach the foot pedal with the two screws.
Tab bent 90 degrees to
stop custom panel from
going below this point.
3/4" Quarter
round
7