Shooting Photos - Sony HDR-TD10 Handycam&reg Operating Manual

Tips

See page 61 on the recordable time of 2D movies.

You can record photos during movie recording by pressing PHOTO fully (Dual Rec).

[ SteadyShot] is set to [Active] in the default setting.

You can specify the priority face by touching it.

You can capture photos from recorded movies.

You can check the recordable time, estimated remaining capacity, etc., by touching

[Setup]  [ Media Settings)]  [Media Info].
(
The LCD screen of your camcorder can display recording images across the entire screen (full pixel

display). However, this may cause slight trimming of the top, bottom, right and left edges of images when
played back on a TV which is not compatible with full pixel display. In the case of 2D recording, set
[Guide Frame] to [On], and record images using the outer frame displayed on the screen as a guide.
To adjust the angle of the LCD panel, first open the LCD panel 90 degrees to the camcorder (), and

then adjust the angle ().
 90 degrees (max.)
 180 degrees (max.)
Watch 3D movies on the LCD screen squarely from about 30 cm (11 7/8 in.) away.

Data code during recording
The recording date, time and condition are recorded automatically on the recording media.
They are not displayed during recording. However, you can check them as [Data Code]
during playback. To display them, touch
Settings)]  [Data Code]  a desired setting 

Shooting photos

MODE button
2D/3D switch
(MENU)  [Setup]  [

(Movie): When recording a movie
(Photo): When recording a photo
PHOTO button
When
(MENU) 
 90 degrees to the
camcorder
( Playback
.
Flashes  Lights up
disappears, the photo is recorded.
US