Height-adjustable dual-monitor desk mount (8 pages)
Summary of Contents for Tripp Lite DDR1026SD
Page 1
Owner’s Manual Dual Flat-Screen Desk Stand MODEL: DDR1026SD CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR! WARNING • Always use an assistant or mechanical lifting equipment to safely lift and position equipment. 26”...
NOTE: Read the entire instruction manual before you start installation and assembly. WARNING • Please read the entire instruction manual before you start installation and assembly. If you have questions about any of the instructions or warnings, please contact Tripp Lite. •...
Parts List IMPORTANT: Before installation, be sure you have received all the parts listed below. If any parts are missing or faulty, contact Tripp Lite for replacements. Adapter Bracket Assembly (x2) Horizontal Support Assembly (x1) Pole (x1) Base (x1) Package M M4X14 (x8) M5X14 (x8) D5 Washer (x8)
Page 4
1. Assemble the Pole to the Base Screw the pole into the threaded hole of the base. Tighten Use the hex key to securely tighten all screws. 3 mm Hex Key 15-05-255-93345B.indd 4 6/3/2015 5:23:12 PM...
Page 5
1. Assemble the Pole to the Base Adjust Height Loosen Collar 3 mm Hex Key Adjust the collar to the desired height. Tighten 3 mm Hex Key 15-05-255-93345B.indd 5 6/3/2015 5:23:12 PM...
Page 6
2. Install the Horizontal Support Assembly Loosen 4 mm Hex Key Insert the horizontal support assembly into the pole until it touches the collar. Collar Tighten Knob Knob Tighten the Knob to secure the horizontal support assembly. 15-05-255-93345B.indd 6 6/3/2015 5:23:13 PM...
Page 7
3. Separate the Adapter Bracket Assembly Loosen and remove the Knob to separate the VESA plate from the adapter bracket assembly. 4. Install the VESA Plates D5 Washer 4 mm Hex M4X14 or M5X14 It may be necessary to slightly loosen or tighten the adjustment screw depending on the weight of display installed.
5. Install the Displays WARNING: Always ensure both monitors face forward. Turning the monitors to face backward may cause the unit to tip over. Tighten Using an assistant or mechanical lifting equipment, attach both displays to the horizontal support assembly simultaneously using the knobs and washers.
Page 9
7. Adjustment Knob Adjust to the desired position or tilt. Maintenance • Check that the bracket is secure and safe to use at regular intervals (at least every three months). • Please visit www.tripplite.com/support if you have any questions. 15-05-255-93345B.indd 9 6/3/2015 5:23:16 PM...