Maintenance Of Carburettor / Air Filter - Bushranger BRUZCS4210 Operator's Manual

MAINTENANCE
SERVICE
If you have any questions or troubles, please contact your Bushranger
CARBURETTOR
• Do not adjust the carburettor. If adjustment is required return the saw to your local Bushranger
AIR FILTER
• Check before every use.
REMOVING AIR FILTER
• Unscrew the air filter cover locking screw and lift off the cover (Fig. D), exposing the air filter (Fig. F-C). Remove the air
filter locking nut and lift the air filter element up and out. (Fig. F)
NOTE:
The T-piece design filter cartridge slides into the housing and is held in place with the top nut. (Fig. F-B).
• Cleaning the air filter surfance can be done by lightly tapping the corner of the filter on a hard surface. If compressed air
has to be used, blow at low force from the inside of the filter.
NOTE:
Never clean with water or any type of solution.
INSTALLING AIR FILTER ELEMENT
• Slide the filter element down and ensure it is making contact with the top and bottom seals. (Fig. E).
• Screw down the lock knob and replace the air filter top cover by positioning the single front tab on the cover into the
slot provided (Fig. F-A) and lightly pushing down, screw in the cover locking knobs.
NOTE:
When fitting the air filter cover there is no need for extreme force the cover will fall into place.
18
A. Air Filter Cover Slot
B. Air Filter Element Locking Knob
C. Air Filter Element
D. Air Filter Cover
dealer.
®
dealer.
®