Manual Configuration Mode (continued)
With this method, the Autoleads CP2 uses a
pre-determined dipswitch configuration to assign the
vehicle and steering control button functionality. The
dipswitches on the side of the interface must be
manually set to the proper vehicle configuration by
the user. These vehicle specific dipswitch settings can
be found by downloading the Autoleads ControlPro
application from
If you wish to re-assign button functions or use short
press/long press dual command functionality, please
follow the PC application or manual re-assignment
procedure.
1. Please Visit
download the Autoleads ControlPro application
Launch the application and find your vehicle/radio
combination.
2. Set the vehicle dipswitches according to the
application.
3. Set the radio dipswitches according to the radio
dipswitch chart below.
4. Connect the interface according to the installation
instructions.
PC Application Mode
With this method, the CP2 can be connected to a PC
in which the application assigns the vehicle and
steering wheel button functionality. To configure using
a PC, the dipswitches on the side of the interface
must all be set to the down/on position which is
the default position. When using this method, it is not
required to manually program the steering wheel
buttons when programming via App mode.
www.autoleads.co.uk/controlpro
1. Visit
download the Autoleads ControlPro PC application.
2. Connect the CP2 to the PC. When using a PC to
configure, it is not required to power the CP2
module via the 11 pin connector.
email - technical.eu@aampglobal.com
www.autoleads.co.uk
www.autoleads.co.uk/controlpro
www.autoleads.co.uk/controlpro
to
to
Need help?
Do you have a question about the ControlPRO CP2-UNI and is the answer not in the manual?