Table of Contents
Advertisement
The TATU rotary cutter, model RC² 1300, was specially designed for carrying out
the cleaning of line spacings on coffee plantations and cultivated areas of similar
crops. The models RC² 1500 & 1700 are widely used for general cutting.
All models operate in a central or lateral position, for economy and efficiency.
The gearbox is protected by slip clutch, giving greater useful life and low
maintenance cost.
The RC² 1300, RC² 1500, RC² 1700 cutters are equipped with two thermally
treated DUROMARK cuttings blades.
This manual contains all the necessary information for optimum use of the cutter.
The operator should read the entire manual before using the cutter and pay careful
attention to the safety recommendations.
For further information or in the event of any technical problems, please consult
the retailer who, along with the Technical Assistance Department of the factorty,
guarantees the proper functioning of your TATU rotary cutter.
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
1
Hide quick links:
Advertisement
Table of Contents
